Enabling WebRTC: Difference between revisions

From MiRTA PBX documentation
Jump to navigation Jump to search
No edit summary
No edit summary
Line 32: Line 32:


[[File:sipML5.png|400px]]
[[File:sipML5.png|400px]]
Example.jpg|Caption1
Example.jpg|Caption2
</gallery>

Revision as of 09:50, 4 February 2018

WebRTC is not enabled by default and you need to follow carefully the following steps to make it work.

  • Install an SSL certificate on Asterisk. This needs to be a real SSL certificate. Check the Asterisk FAQ on how to install an SSL Certificate in Asterisk
  • Install the Opus codec and add to the web interface. You can check the instructions in the Setup Guides section Installing OPUS codec
  • Activate the http daemon for asterisk by editing the http.conf file as following:
[general]
enabled=yes
bindaddr=0.0.0.0
bindport=8088
tlsenable=yes
tlsbindaddr=0.0.0.0:8089
tlscertfile=/etc/asterisk/certificates/demo.mirtapbx.com.pem

The tlscertfile needs to point to your certificate in pem format

  • Activate the ws and wss transport in sip.conf, set the realm
transport=udp,tls,ws,wss
realm=demo.mirtapbx.com
  • Set the path for your certificate in the Web interface - Admin/Settings, Security section, WebRTC SSL path field
  • In your extension enable Opus Codec, RTP Encryption and Any Transport

Verifying WebRTC

To verify the WebRTC configuration, you can try to register and place calls using the SipML5 by visiting: https://www.doubango.org/sipml5/

SipML5.png